CHEMISTRY PRACTICAL SPECIMENs
Question 1
In addition to the fittings and reagents normally contained in a chemistry laboratory, the following apparatus and materials will be required by each candidate
one burette of 50cm3 capacity
one pipette, either 20cm3 or 25cm3.
All candidates at one centre must use pipettes of the same volume. These should be clean and free from grease
The usual apparatus for Titration
the usual apparatus and reagents for qualitative work including the following with all reagents appropriately labelled.
(i) glass rod
(ii) aqueous ammonia
(iii) dilute hydrochloric acid
(iv) dilute sodium hydroxide solution
(v) barium chloride solution
(vi) dilute trioxonitrate (V) acid
(vii) silver trioxonitrate (V) solution
(viii) dilute tetraoxosulphate (VI) acid
glass rod
filtration apparatus
spatula
two boiling tubes
four test tubes
wash bottle containing distilled/deionized water
mathematical table/calculator.
Question 2
Each candidate should be supplied with the following, where ‘n’ is the candidate’s serial number.
150cm3 of ethanedioic acid (H2C204) solution in a corked flask or bottled labelled ‘An’. These should all be the same containing 4.50g of H2C204 per dm3 of solution.
150cm3 of potassium tetraoxomanganate (VII) solution in a corked flask or bottle labelled ‘Bn’. These should all be the same containing 3.16g of KMnO4 per dm3 of solution.
One spatulaful of a uniform mixture of NaCl and ZnCO3 in a specimen bottle labelled ‘Cn’. The components of the mixture should be in the ratio 1:1 by mass.
Question 1
In addition to the fittings and reagents normally contained in a chemistry laboratory, the following apparatus and materials will be required by each candidate
one burette of 50cm3 capacity
one pipette, either 20cm3 or 25cm3.
All candidates at one centre must use pipettes of the same volume. These should be clean and free from grease
The usual apparatus for Titration
the usual apparatus and reagents for qualitative work including the following with all reagents appropriately labelled.
(i) glass rod
(ii) aqueous ammonia
(iii) dilute hydrochloric acid
(iv) dilute sodium hydroxide solution
(v) barium chloride solution
(vi) dilute trioxonitrate (V) acid
(vii) silver trioxonitrate (V) solution
(viii) dilute tetraoxosulphate (VI) acid
glass rod
filtration apparatus
spatula
two boiling tubes
four test tubes
wash bottle containing distilled/deionized water
mathematical table/calculator.
Question 2
Each candidate should be supplied with the following, where ‘n’ is the candidate’s serial number.
150cm3 of ethanedioic acid (H2C204) solution in a corked flask or bottled labelled ‘An’. These should all be the same containing 4.50g of H2C204 per dm3 of solution.
150cm3 of potassium tetraoxomanganate (VII) solution in a corked flask or bottle labelled ‘Bn’. These should all be the same containing 3.16g of KMnO4 per dm3 of solution.
One spatulaful of a uniform mixture of NaCl and ZnCO3 in a specimen bottle labelled ‘Cn’. The components of the mixture should be in the ratio 1:1 by mass.
0 comments:
Post a Comment